These are the proper GM-style sensors for use with the MegaSquirt line of ECUs
The threads are 3/8″ NPT pipe thread – note that isn’t an actual 3/8″ outer diameter but a pipe thread size based on pipe inner diameter
This product replaces n:
Third image shows the sensor's characteristic curve
Specific References
Reference: CONNDELPHI12162197
Brand: Delphi Aptiv
Delphi 2 pin connector, used on GM style IAT temperature sensors pn. 12162197
Reference: IATGM-CONN
Brand: DsGarage
GM-style sensors for use with the MegaSquirt line of ECUs and come with the weatherproof connector and crimp pins.
Reference: PRESSENS150PSI5V18NPT
Brand: DsGarage
150psi 10bar 5V 1/8NPT Stainless Steel Oil Air Water Pressure Sensor
Reference: ECUMASTERLAMBDACAN
Brand: EcuMaster
LAMBDA to CAN Ecumaster "Lambda to CAN" controller is a compact device used to control a Bosch LSU 4.9 wideband oxygen sensor and transmit the lambda reading via CAN-BUS. Two programmable 0-5V analog signal lines are available, along with the CAN transmission.
Reference: BOSCH0281006076
Brand: Bosch
Map / Temp Bosch 3 bar sensor (20-300 kPa) 0281006076
GM-style sensors for use with the MegaSquirt line of ECUs
